%20vector%20logo.svg)
A range of accessories are available for use between the piston and rail assembly of Utest Flexural Testing Frames.
A range of accessories are available for use between the piston and rail assembly of Utest Flexural Testing Frames.
Utest’s flexural testing frames are designed with stiff construction to limit deformation under load. Each frame is compatible with a full range of testing accessories for conventional two or single point loadings and specialized tests for tiles, kerbs and other elements.
The UTCM-0240 Blaine Air Permeability Apparatus is used to measure the fineness of powders such as Portland cement and limes expressed in terms of their specific surface.
The setting time of cement is measured using the Vicat Method, this manual test set allows the operator to perform checks for initial and final set, recording their own times and results.
In a vicat test a needle drops freely into a cement sample. A sensor with 0.1mm resolution measures the penetration depth, as the cement hardness an initial and final setting times is measured and recorded.
The automatic range of single and double testing chamber compression and flexure test machines have been designed for reliable and consistent testing of mortar samples.
The Muffle Furnace range is ideal for a wide range of applications where high temperatures are required. It is commonly used for Loss on Ignition tests for Cement and Quicklime.
The UTCM-0020 High Pressure Cement Autoclave is designed to perform expansion tests on cement prism, 10 specimens can simultaneously be tested in the high pressure steam vessel.
A motorised Cement Flow Table is used for determining the consistency of mortar, lime and cement specimens.
A Cement Flow Table is used in determining the consistency of mortar, lime and cement specimens.
A Jolting Table is used for compacting of cement specimens in their mould and consists of mould table seated on a rotating cam. The machine is equipped with a counter which provides automatic shut off at end of preset drop numbers.
The UTCM-0755 Mud Balance, an ideal equipment for site applications, provides an accurate and easy method for determining mud density. The accuracy of the readings is not affected by the temperature of the drilling mud.
The UTCM-0760E Wet Sieving Apparatus is used for determining the fineness of fly ash, cement or SCM.
Automatic Compression Machines are used to determine compressive, splitting and flexural strengths. In Australia, the most common compressive strength testing procedures are cylinder strength tests for concrete according to AS 1012.9, and cube tests for cement materials.
Curing are designed for curing concrete cubes and cylinders. The temperature can be adjusted to a set temperature between ambient to 40 ºC with ± 2 ºC accuracy.
The mixer has been designed to mix mortars and cement pastes to standard requirements. The mixing paddles have a planetary motion and a driven by a motor with a microprocessor control, programable to meet standard mixing times.
The UTCM-0875 Manual Mortar Mixer has a 5 liter (approx.) capacity, they have been designed to mix mortars and cement pastes primarily to the requirements of standards.
Cement prism are used for compressive strength and flexural strength testing.
The Le Chatelier Moulds and Soundness Kit (along with a Water Bath) is used to measure the soundness of cement, fly ash for concrete and lime.
The UTCM-0003 Le Chatelier Flask has been designed to measure the density of: Hydraulic cement, Ground granulated blast-furnace slag and fly ash for concrete, Filler aggregates and Lime.
The moulds are used for preparing the specimens for the purpose of determining the length changes (shrinkage/expansion) in hardened hydraulic cement mortar and concrete.
A range of industrial balances available for CMT Lab Testing Requirements.
